Quality standards of TM "Altep": Quality of testing.

Do you want your boiler to run smoothly? Are you afraid of boiler leaks? A sealed heat exchanger is a guarantee that your home will always be warm.

To be sure of the reliability of our equipment, we conduct tests of finished products and inspections at intermediate stages. An important characteristic of a boiler that is carefully checked by our specialists is the tightness of its heat exchanger. If the heat exchanger is not tight, the boiler does not work.

Methodology. boiler testing is based on the rules for the construction and safe operation of steam boilers with a steam pressure of no more than0.07 MPA and the water heating temperature is not higher than115°С (NPAPP 0.00 - 1.26 - 96).
According to these rules, the test pressure must be at least 1.5 times higher than the operating pressure (at least0.2 MPA). According to the internal methodology of the company "Altep Center" the test pressure is0.5 MPA.
According to the rules, the test duration should be at least 10 minutes. According to our methodology, the test is carried out for 30 minutes at a water temperature of ~.40° C.
In other words, Altep boilers are tested with three times the load that is required by the rules.
Hydraulic testing of boilers is carried out to check their density and strength of all elements by qualified specialists. After the operating pressure is reduced, a thorough inspection of all boiler elements is carried out.
The boiler is considered to have passed the hydraulic test if there are no signs of cracks, leaks, or visible residual deformations.
High standards of product quality requirements and control at all stages of production allow us to offer products that are reliable, safe and effective.
A satisfied customer is always our priority. The reliability and safety of our heating is guaranteed and tested to give you safe heat!